drag and drop

I would like to drag a file onto a turnkey that I create using SF, and then have the turnkey proceed to act upon the file... open it, do things to it, etc.
Does anyone have advice on how to accomplish this? I am not sure what the EXE "sees" when a file is dropped onto it, nor how I can access the filespec, for example. If someone has an example of a simple application that works that way, I could probably figure it out from there.

Suggestions would be much appreciated.

- Roger
----------------------------------------------------------------------
Dr. Roger Dube

RogerDube_at_datHQ.com
President/CEO
Digital Authentication Technologies, Inc.
http://www.datHQ.com/
TEL +1.561.392.7404
FAX +1.561.892.2474

PO Box 811564
Boca Raton, FL 33481-1564

----------------------------------------------------------------------
This E-mail message and any attachments have been scanned for viruses
and are believed to be free of any virus or other defect that might
affect any computer system into which it is received and opened. However,
it is the responsibility of the recipient to ensure that it is virus free
and no responsibility is accepted by Digital Authentication Technologies,
Inc. for any loss or damage arising in any way from its use. This email
message is for the sole use of the intended recipient(s) and may contain
confidential and privileged information. Any unauthorized review, use,
disclosure or distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply email and destroy all
copies of the original message. Any views expressed in this message are
those of the individual sender, except where the sender specifically
states them to be the views of Digital Authentication Technologies, Inc.

----------------------------------------------------------------------
sftalk_at_forth.com The SwiftForth programming discussion email list
To unsubscribe, send subject "unsubscribe" to sftalk-request_at_forth.com
For list command help, send subject "help" to sftalk-request_at_forth.com
Message archives are located at http://www.forth.com/archive/sftalk
----------------------------------------------------------------------
This list is a forum for SwiftForth users. For product support and bug
reports, please send email to support_at_forth.com
----------------------------------------------------------------------
Received on Sun Dec 14 2003 - 18:01:58 PST