Dear SFTalk,

I have noticed that there are a few incorrect cross-references in the
documentation for SwiftForth 3.0.1 - where the Swiftforth.pdf document
refers to the Forth Programmer's Handbook (Handbook.pdf). The
erroneous references are:

Section 2.4.2 (References) refers to 3.6 instead of 4.6
The same in 2.4.3, 5.4.1, 5.4.2 (3 times), 6.9

Section 3.1 (References) refers to 3.4 instead of 3.5

Section 4.1.1.2 MARKER refers to 3.5 instead of 4.5

Section 4.4.2 References refers to 3.7 instead of 3.6

Section 4.7 Exceptions refers to 2.8 instead of 2.6

Section 5.5 Terminal I/O refers to 3.8 instead of 3.3

Section 6.1 References refers to 4.0 instead of Chapter 6

Section 12.2 Floating point refers to 3.11 instead of 3.8

Appendix A Blocks refers to 3.3 instead of 3.4

Best,
Tony
----------------------------------------------------------------------
sftalk_at_forth.com The SwiftForth programming discussion email list
To unsubscribe, send subject "unsubscribe" to sftalk-request_at_forth.com
For list command help, send subject "help" to sftalk-request_at_forth.com
Message archives are located at http://www.forth.com/archive/sftalk
----------------------------------------------------------------------
This list is a forum for SwiftForth users. For product support and bug
reports, please send email to support_at_forth.com
----------------------------------------------------------------------
Received on Sun Sep 03 2006 - 03:59:22 PDT