Reply or Reply to All

When replying to messages on the SwiftX mailing list, you may use "Reply" to
send a private response only to the sender. Use your mail client's "Reply
to All" function to post your response to the entire list. It has always
been my intention that this list should function this way, but I had it
configured incorrectly. I found out the hard way a few minutes ago when I
sent what I thought was a private message to David Graham asking him to call
me, but that message went to the entire list. (P.S. You don't all need to
call me!)

Also, for those of you with multiple email addresses, you must post to the
list with the address you used when you subscribed to the list. If you
change addresses, please unsubscribe the old one and re-subscribe with the
new one. Or just send me an email and I'll take care of it.

And if I still have your attention, please note that the current SwiftX
release is 3.0.3. which was posted for download on 5/2/2001. The next
release (which will include the new Texas Instruments MSP430 mixe signal
microcontroller) should be posted next week.

--Leon

----------------------------------------------------------------------
swiftx_at_forth.com The SwiftX programming discussion email list
To unsubscribe, send subject "unsubscribe swiftx" to listar_at_forth.com
For help with listar commands, send subject "help" to listar_at_forth.com
Archives are located at http://www.forth.com/swiftx -- check them out!
Received on Thu Jun 21 2001 - 14:21:24 PDT