Re: Listserve protocol

For most email clients, use REPLY ALL to reply to the whole list, use REPLY to
reply privately to the sender.

> -----Original Message-----
> From: swiftx-bounce_at_forth.com [mailto:swiftx-bounce_at_forth.com]On Behalf
> Of Gene Silvernail
> Sent: Friday, September 20, 2002 12:19 PM
> To: Swiftx Listserve
> Subject: [swiftx] Listserve protocol
>
>
> When using this listserve can one just use REPLY under MS Explorer to
> answer questions ?
>
>
>
>
> ----------------------------------------------------------------------
> swiftx_at_forth.com The SwiftX programming discussion email list
> To unsubscribe, send subject "unsubscribe swiftx" to listar_at_forth.com
> For help with listar commands, send subject "help" to listar_at_forth.com
> Archives are located at http://www.forth.com/swiftx -- check them out!
> ----------------------------------------------------------------------
> THIS LIST IS NOT FOR BUG REPORTS! Send bug reports to support_at_forth.com.

----------------------------------------------------------------------
swiftx_at_forth.com The SwiftX programming discussion email list
To unsubscribe, send subject "unsubscribe swiftx" to listar_at_forth.com
For help with listar commands, send subject "help" to listar_at_forth.com
Archives are located at http://www.forth.com/swiftx -- check them out!
----------------------------------------------------------------------
THIS LIST IS NOT FOR BUG REPORTS! Send bug reports to support_at_forth.com.
Received on Fri Sep 20 2002 - 12:25:01 PDT